Page tree
Skip to end of metadata
Go to start of metadata
Overview

Satellite Access Points are the wireless link between the FasCard readers and the internet.  All Locations requires one or more satellites depending upon store size and reader quantity. Each satellite must have a unique name and MAC Address- this is configured on the FasCard Admin Site - Location Setup page.

On this Page

Configuring Satellite Access Points

FasCard accounts are only allowed a specific allotment of card readers and satellites. If a 'Cannot add satellite because it will over the max number allowed' error is displayed when adding a new satellite, contact CCI Support for further assistance.


Adding satellites to a new or existing location requires minimal user configuration which is performed by editing the appropriate fields as outlined below and clicking Save.

Add a Satellite

Technician Information

  • When Support Technicians add a satellite, the Diag WiFi SSID and Diag WiFi PSK fields will be displayed and automatically populated. Do not edit these fields unless instructed to do so by a superior.

  • When editing a satellite, a request for the latest firmware may be initiated using the button, located below at the bottom of the satellite configuration section.

    • A banner will be displayed informing the technician of the date and time of the update request.

    • This requires the initial satellite firmware to be 1.14.22 or later.


To add a satellite to a new or existing location, follow the instructions below.

The "Notes" text box in the satellite setup is primarily for use by Support Technicians and is not required for satellite setup.

  1. Log into the FasCard Admin site.  If you have multiple accounts, select the account that has the site listed which needs the satellite added.

  2. Select a location or add a new location as described in Location Setup.
  3. In the Satellites section, click Add Satellite.
  4. In the Name field - enter a unique satellite name.
  5. In the MAC Address field - enter the unique MAC address associated with the first Ethernet port (E01) on the satellite.
  6. In the Wifi Channel field - Select a preferred Wifi channel or leave as default.
  7. Click Save at the bottom of the screen.  
  8. 'Satellite information added' message should appear to indicate success.

Update Satellite to Most Recent Firmware

NOTE: This process can take up to 30 minutes and the Satellite should not be power cycled or powered off at any time. If the location has a single satellite, the readers will go offline briefly during the update

  1. Navigate to the Locations page under the Setup tab.

  2. Select the appropriate location.

  3. In the Satellites section, click on the appropriate satellite (It will turn blue when selected)

  4. Click on the Satware drop down menu and select the most recent version.
  5. Click save at the bottom of the page. 
  6. Click the System tab at the top of the screen.
  7. The satellite should show the version that it is going to update to in brackets next to the current version. Example: (2.02.03)
  8. When the satellite refreshes with the new version in the primary location the update is complete. 
  9. Repeat these steps for all remaining satellites

Delete a Satellite

  1. Navigate to the Locations page under the Setup tab.

  2. Select the appropriate location.

  3. In the Satellites section, click on the appropriate satellite (It will turn blue when selected)

  4. Once the satellite box expands, click on Delete Satellite. 
     
  5. Click OK to confirm deletion or click Cancel.

Additional Information