Page tree
Skip to end of metadata
Go to start of metadata

On this Page

Overview and Equipment Information

This document is intended to guide the user through installation utilizing the kit numbered according to the document title. A list of associated equipment models including control information and additional installation notes can be found below.

Kit Installation Notes

Status: Active

Product: FasCard F1
Manufacturer: Alliance
Start Harness: Molex connector with additional taps
Interface Type: Pulse
Install Type: Card Only
Actuation: N/A
Coin Sense: N/A
Mounting: Custom Bracket
Chassis: N/A
Readers: 1 Reader
Machine Control: Alliance Mechanical Timer


This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

Card Reader

Part IDDescriptionImage
C-5001
F1 FasCard Reader

Installation Kit

QTYPart NumberDescriptionImage
1C-0906Spacer Plate
1C-0935Mounting Bracket
1C-5021Label
1C-5027Label
1C-5203Power Adapter Harness
1C-5307Combination Harness
1C-5500Power Extension Harness
1C-5602Power Converter
2C-5751Screw

Recommended Tools and Supplies (Not Included)

See FasCard Mounting Guide for more information.

Installation

Confirm machine power is disconnected before beginning installation!

Use caution and appropriate protection to prevent hand and eye injury during installation!

Step 1 - Install Mounting Bracket

C-0906C-0935
Spacer Plate
Mounting Bracket

  1. Remove the existing Coin Drop.
  2. Install the C-0935 Mounting Bracket where the Coin Drop was previously mounted.
    1. Reuse the same nuts used to mount the Coin Drop.
  3. Mount the C-0906 Spacer over the C-0935 Mounting Bracket on the exterior of the panel.

Step 2 - Connect Power

C-5203C-5500C-5602
Power Adapter Harness
Power Extension Harness
Power Converter

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5203 Power Adapter Harness to terminal strip or contacts L1 and L2.
    1. Connect the ground wire to a chassis screw.
    2. Connect the opposite end to the C-5602 Power Converter.
  2. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Step 4 - Connect Machine Start Harness

C-5307
Combination Harness

  1. Connect the C-5251 Machine Start Harness to the Coin Counting Board Harness where the coin drop was previously connected.
    1. The remaining connections are unused.

Step 5 - Connect and Mount FasCard Reader

C-5307
Combination Harness

  1. Feed remaining harness ends through mounting hole as described in FasCard Mounting Guide.
  2. Connect the free end (white connector) of the C-5307 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the C-5500 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown above.
  4. Connect FasCard reader to base as described in the FasCard Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models

MakeModelPulse LengthSensorControlNotes
HuebschHC##MD2####### FalseSingle-Vend (Pulse)