Page tree
Skip to end of metadata
Go to start of metadata

On this Page

Overview and Equipment Information

This document is intended to guide the user through installation utilizing the kit numbered according to the document title. A list of associated equipment models including control information and additional installation notes can be found below.

Kit Installation Notes

Status: Active

Product: FasCard F1
Manufacturer: Alliance
Start Harness: 3-pin (1x3) molex connector
Interface Type: Pulse
Install Type: Card Only
Actuation: N/A
Coin Sense: N/A
Mounting: Metercase Bracket
Chassis: Stack Small Chassis
Readers: 2 Readers
Machine Control: Alliance ACA


This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

Card Reader

Part IDDescriptionImage
C-5001
F1 FasCard Reader

Installation Kit

QTYPart NumberDescriptionImage
4C-0141Screw
4C-1059Nut
4C-1070-WWasher - Build: XCH
2C-5021Label
2C-5027Label
2C-5300-NCMachine Start Harness
2C-5765-BMounting Bracket
2C-6204Power Adapter Harness

Recommended Tools and Supplies (Not Included)

See F1 Reader Mounting Guide for more information.

Installation

Confirm machine power is disconnected before beginning installation!

Use caution and appropriate protection to prevent hand and eye injury during installation!

Step 1 - Install Mounting Bracket

C-1059C-1070-WC-5765-B
Nut
Washer - Build: XCH
Mounting Bracket

  1. Install the C-5765-B Mounting Bracket into each of the Coin Vaults.

Step 2 - Connect Power

C-6204
Power Adapter Harness

  1. Connect the C-6204 12VDC Power Harness to the H10 Connection on the Machine Control Assembly.
    1. Connect the green wire to a chassis ground.
  2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

Step 3 - Connect Machine Start Harness

C-5300-NC
Machine Start Harness

  1. Connect the C-5300-NC Machine Start Harness to the coin drop connection on the Machine Control Assembly.

Step 4 - Connect and Mount FasCard Reader

C-5300-NCC-6204
Machine Start Harness
Power Adapter Harness

  1. Feed remaining harness ends through mounting hole as described in FasCard Mounting Guide.
  2. Connect the free end of the C-5300-NC Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the C-6204 to port 4 (C-5500 Power Harness Connection Port) as shown in the image above.
  4. Connect FasCard reader to base as described in the FasCard Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models

MakeModelPulse LengthSensorControlNotes
PrimusPSEJXAGS174TG01-80FalseSingle-Vend (Pulse)