Skip to end of metadata
Go to start of metadata

Overview

Equipment Details


Average Installation Time


On This Page

Make: IPSO
TEST Reader Installation Guides


TODO


Known Models

WE73
WE75
WE95
TEST Reader Installation Guides

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

Card Reader

Part IDDescriptionImage
C-0103-B
LaundryCard Reader V3 - RevB

Recommended Tools and Supplies (Not Included)

Installation

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.

Install Mounting Hardware

P/N: C-0015
Label
Reader Cover Label
Qty: 1
P/N: C-0031
Label
Dexter Instruction Panel
Qty: 1
P/N: C-0144
Screw
8-32 x 2" - Flat
Qty: 2
P/N: C-0905
Drop Cover
2-3/8" x 4-5/8"
Qty: 1
P/N: C-0960
Mounting Bracket
IPSO
Qty: 1
P/N: C-0961
Jam ring
IPSO
Qty: 1
P/N: C-1043
Screw
8-32 x 1-3/4" - Flat
Qty: 2

  1. Install the C-0961 Jam Ring into the coin vault. The Jam Ring should be installed into the coin vault so that it is within 1.5" of front panel of the machine to allow the mounting bracket to be attached.
  2. To install the Jam Ring insert the ring so the small portion is on the bottom. Insert at an angle, so the top of the Jam Ring is inserted first. Once the ring is in position, pull the top of the Jam Ring towards the front of the machine until it locks into place.
  3. Using the C-0144 Screws, attach the C-0960 Mounting Bracket to the C-0961 Jam Ring.
  4. Secure reader to C-0960 Mounting Bracket using C-1043 Screw.
  5. Install the C-0905 Drop Cover where the coin drop was installed. Secure using the original hardware.
  6. Apply C-0031 Label over the C-0905 Drop Cover.

Connect Machine Interface Harness

Pulse

P/N: C-0113
Machine Start Harness
2-Wire Harness
Qty: 1

  1. Connect the C-0113 Machine Start Harness to the Coin 1 connector on the Machine Control Assembly.

Connect and Mount Reader

TODO - Include picture of LaundryCard reader connection

  1. Feed remaining harness ends through the mounting hole as described in the LaundryCard Kit Installation Guidelines.
  2. Connect the free end of the C-0113 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Secure the LaundryCard reader to the machine as described in the LaundryCard Kit Installation Guidelines.

Machine Configuration

TODO

LaundryCard Configuration

Use the following settings depending on the Machine Start Harness used.

Pulse (C-0113)

  1. Equipment Type: SingleVend
  2. Pulse Length: 500

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.