Skip to end of metadata
Go to start of metadata

Overview

Equipment Details


Average Installation Time


On This Page

Make: Maytag
TEST Reader Installation Guides


TODO


Known Models

MHN 30PDBWW0
MHN30PDAWW
MHN30PDAWW0
MHN30PDBWW0
MHN30PDBWW01
MHN30PDC
MHN30PDCWW0
MHN30PDCWW00
MHN30PDWW0
TEST Reader Installation Guides

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

Card Reader

Part IDDescriptionImage
C-0103-B
LaundryCard Reader V3 - RevB

Recommended Tools and Supplies (Not Included)

Installation

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.

Install Mounting Hardware

P/N: C-0015
Label
Reader Cover Label
Qty: 1
P/N: C-0141
Screw
8-32 x 1-1/2" - Cap
Qty: 2
P/N: C-0301
Topload Mounting Bolt
Qty: 1
P/N: C-0911
Metercase Bracket
Whirlpool - White
Qty: 1

  1. Remove existing coin box and coin drop.

  2. Insert C-0911 Metercase Bracket into the metercase and secure using the C-0301 Topload Mounting Bolt.
  3. Attach reader to C-0911 Metercase Bracket using C-0141 Screws once all harnesses are connected.
  4. Cover mounting screw holes using C-0015 Cover Label.

Connect Machine Interface Harness

Pulse

P/N: C-0126-MLV-EXT15
Extension Harness
Compass
Qty: 1
P/N: C-0128-MLV
Machine Start Harness
Maytag
Qty: 1

  1. Connect the C-0128-MLV Machine Start Harness to the Debit connector on the Machine Control Assembly.
    1. If needed, use the C-126-MLV-EXT15 Extension Harness to extended the reach of the harness.

Connect and Mount Reader

TODO - Include picture of LaundryCard reader connection

  1. Feed remaining harness ends through the mounting hole as described in the LaundryCard Kit Installation Guidelines.
  2. Connect the free end of the C-0128-MLV Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
  3. Secure the LaundryCard reader to the machine as described in the LaundryCard Kit Installation Guidelines.

Machine Configuration

TODO

LaundryCard Configuration

Use the following settings depending on the Machine Start Harness used.

Pulse (C-0128-MLV)

  1. Equipment Type: SingleVend
  2. Pulse Length: 24

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.