Skip to end of metadata
Go to start of metadata

Overview

Equipment Details


Average Installation Time


On This Page

Make: IPSO
TEST Reader Installation Guides


TODO


Known Models

IWF014MC2X10U02
IWF025MC2X10U20
IWF075MC2X10U20
TEST Reader Installation Guides

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

Card Reader

Part IDDescriptionImage
C-0103-B
LaundryCard Reader V3 - RevB

Recommended Tools and Supplies (Not Included)

Installation

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.

Install Mounting Hardware

P/N: C-0015
Label
Reader Cover Label
Qty: 1
P/N: C-0133
Standoff
8-32" x 1-1/2" - Hex
Qty: 2
P/N: C-0140
Screw
8-32 x 3/4" - Cap
Qty: 2
P/N: C-0936
Vault Mount Bracket
Qty: 1
P/N: C-5033
Label
4-5/8" x 3-1/2"
Qty: 1
P/N: C-5365
Bypass Harness
Alliance Coin Vault Bypass
Qty: 1

  1. Remove existing coin box and coin drop.

  2. Install the C-5365 Bypass Harness by removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness.
  3. Bend the side tabs of the C-0936 Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

  4. Attach the C-0133 Standoffs to the Bracket.

  5. Attack reader to Bracket using C-0140 Screws.
  6. Apply the C-0033 Label over the coin drop opening.

Connect Machine Interface Harness

Pulse

P/N: C-0113
Machine Start Harness
2-Wire Harness
Qty: 1

  1. Connect the C-0113 Machine Start Harness to the Coin Switch Harness previous connected to the coin drop.

Connect and Mount Reader

TODO - Include picture of LaundryCard reader connection

  1. Feed remaining harness ends through the mounting hole as described in the LaundryCard Kit Installation Guidelines.
  2. Connect the free end of the C-0113 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Secure the LaundryCard reader to the machine as described in the LaundryCard Kit Installation Guidelines.

Machine Configuration

TODO

LaundryCard Configuration

Use the following settings depending on the Machine Start Harness used.

Pulse (C-0113)

  1. Equipment Type: SingleVend
  2. Pulse Length: 80

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.