Skip to end of metadata
Go to start of metadata

Overview

Equipment Details


Average Installation Time


On This Page

Make: Wascomat
TEST Reader Installation Guides


TODO


Known Models

D730S
D735S
D735S NR
D735SNR
D750S
D750SNR
TEST Reader Installation Guides

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

Card Reader

Part IDDescriptionImage
C-0103-B
LaundryCard Reader V3 - RevB

Recommended Tools and Supplies (Not Included)

Installation

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.

Install Mounting Hardware

P/N: C-0014S
Label
TD LC Window
Qty: 1
P/N: C-0015S
Label
TD30 Insert Card Graphic
Qty: 1
P/N: C-0968
Flat Mount Bezel
For Wascomat TD30x30
Qty: 1
P/N: C-1042
Nut
8-32 - Kep
Qty: 4
P/N: C-1068
Screw
#8-32 x 5/16 - Flat Cap
Qty: 4

  1. Remove existing coin drop.

  2. Insert C-0968 Flat Mount Bezel where the coin drop was previously installed. Secure using C-1042 Kep Nuts and C-1068 Screws.

Connect Machine Interface Harness

Pulse

P/N: C-0126R1
Machine Start Harness (SA)
20" - LaundryLux
Qty: 1

  1. Connect the C-0126R1 Machine Start Harness to the Coin 1 connection on the Machine Control Assembly.

Connect and Mount Reader

TODO - Include picture of LaundryCard reader connection

  1. Feed remaining harness ends through mounting bracket.
  2. Connect the free end of the C-0126R1 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the the Cat5 cables running to and from the adjacent machines to ports labeled 3 (Line Connection Ports) as shown in the image above.
  4. Secure the LaundryCard reader to the bracket using included hardware.

Machine Configuration

TODO

LaundryCard Configuration

Use the following settings depending on the Machine Start Harness used.

Pulse (C-0126R1)

  1. Equipment Type: SingleVend
  2. Pulse Length: 63

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.

  • No labels