Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Div
Classtoc-header
Section
Column
width30
Panel
titleOn this Page

Table of Contents
maxLevel2
minLevel2

Column
width70
Panel
titleOverview and Equipment Information

This page is intended to guide the user through installation of a Web Cam in an X-Changer.

Kit Installation Notes

Cci kits
TypeDescription

Requirements

UI Text Box
sizemedium
typenote

If this is an upgrade to an existing system, the X-Changers must be running LaundryCard v8 or higher!

 


Cci kits
TypeParts

Installation

Div
Classinstall-steps
Panel

Step 1 - Remove Cover Plate

Image ModifiedImage Modified

  1. Locate the area where the web cam will be installed at the top of the front door.
  2. Remove the plate and nuts covering the hole where the webcam will be installed. Set the nuts aside as they will be re-used.
  3. Attach the two smaller plates to the large bracket using the 4 nuts provided.
Panel

Step 2 - Assemble Mounting Bracket

Bw part list
PartsC-1400-201,C-1400-202,C-1042
SizingModeHeight
ShowDesc2false
ShowDesc3false
SingleRowtrue

Image Modified

  1. Slot two of the C-1400-202 Mounting Brackets into the C-1400-201 Mounting Shelf.
  2. Secure the C-1400-202 Mounting Brackets with the C-1042 Nuts provided.
Panel

Step 3 - Mount the Webcam

Bw part list
PartsC-7710,C-1042
SizingModeHeight
ShowDesc2false
ShowDesc3false
SingleRowtrue

Image Modified
  1. Attach the assembled Mounting Bracket to the inside of the X-Changer door using the existing bolts and C-1042 Nuts.
  2. Remove the C-7710 Webcam base.
  3. Pull the C-7710 Webcam USB cable through the rear of the mounting bracket and slide the WebCam into place.
  4. Adjust the Mounting Bracket as necessary by sliding the rear C-1400-202 Mounting Bracket forward and tightening the C-1042 Nuts.
  5. Once the C-7710 Webcam is securely held by the bracket, adjust the camera lens so that it is centered in the door window.
  6. Connect the C-7710 Webcam USB cable to any available USB port on the computer.
  7. Once completed, contact Technical Support to complete installation and test C-7710 Webcam.
Show If
special@authenticated

Support Technician Information

  1. Open vs1Diag. In the upper right corner is the Camera testing options
  2. Click Take Picture. The status text to the left of the button should change to "Operation in Progress" while the picture is being taken. If the picture is taken successfully the status text will change to "No Errors".
  3. To view the test picture navigate to the directory/folder you saved it to (C:\picture.jpg is the default) and double click on the picture file.
  4. If the picture does not look centered properly simply adjust the camera in the bracket and repeat the test until you are happy with the results.
  5. Once the adjustment is complete, the laundry applications can be restarted.