Kit Installation Notes

Installation Kit

Recommended Tools and Supplies (Not Included)

See F2 Reader Mounting Guide for more information.

Installation

Step 1 - Install Mounting Bracket

  1. Place the C-6700-TEMP Drill Template on the desired mounting location.
  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.
  3. Refer to F2 Reader Mounting Guide for further instructions.

Step 2 - Connect Power

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
  2. Connect the C-5336 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
  3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Step 3 - Connect Coin Sense Harness

  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Disconnect the wires from the Coin Drop terminals.
  3. Connect the C-6253 Coin Sense Harness to the terminals on the Coin Drop.

Step 4 - Connect Machine Start Harness

  1. Connect the C-5254 Machine Start Harness to the Machine Control Assembly where the coin drop was previously connected.

Step 5 - Connect and Mount FasCard Reader

  1. Feed remaining harness ends through mounting hole as described in F2 Reader Mounting Guide.
  2. Connect the free end of the C-5254 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image below.
  3. Connect the free end of the C-6253 Coin Sense Harness to port 3 (Coin 1 Connection Port) as shown in the image below.
  4. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Connection Port) as shown in the image below.
  5. Connect FasCard reader to base as described in the F2 Reader Mounting Guide.
  6. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models