Kit Installation Notes

Installation Kit

Recommended Tools and Supplies (Not Included)

See F2 FasCard Mounting Guide for more information.

Installation

Step 1 - Install Mounting Bracket

  1. Install the C-6970 Bracket on the control panel.
  2. Attach the C-5414 F2 Mounting Bracket onto the C-6970 Bracket using the C-1060 Screws.

Step 2 - Connect Power

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
    1. Tap the 24vac lines toward the front of the machine, closest to the reader mounting location.
  2. Connect the C-6208 Power Adapter Harness to the installed spade taps. The remaining cable end connects to the FasCard reader after installation.

Step 3 - Connect Machine Start Harness

  1. Connect the C-0110-CP Jumper Plug to the Machine Control Assembly.
    1. It may be necessary to remove the existing Alliance Jumper Plug before installing C-0110-CP Jumper Plug.
  2. Connect the C-0110-TOP Machine Start Harness to the Machine Control Assembly serial interface port.

Step 4 - Connect and Mount FasCard Reader

  1. Feed remaining harness ends through mounting hole as described in F2 FasCard Mounting Guide.
  2. Connect the free end of the C-0110-TOP Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
  3. Connect the free end of the C-6208 Power Adapter Harness to port 1 (C-5500 Power Harness Connection Port) as shown in the image above.
  4. Connect FasCard reader to base as described in the F2 FasCard Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models