Kit Installation Notes

Installation Kit

Recommended Tools and Supplies (Not Included)

See F2 Reader Mounting Guide for more information.

Installation

Step 1 - Install Mounting Bracket

  1. Remove any existing Coin Drop.
  2. Install the C-5414 Mounting Bracket onto the C-6760 Metercase Bracket using the C-5702 and C-5703 Chase Nipple and Nut.
  3. Install the C-6760 Metercase Bracket over the front of the Metercase and secure with the C-0301 Mounting Bolt.
  4. Refer to FasCard Mounting Guide for further information as needed.

Step 2 - Connect Power

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
  2. Connect the C-5338 Power Adapter Harness to the installed spade taps and ground appropriately. Connect the opposite end to the C-5602 Power Converter.
  3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Step 3 - Connect Machine Start Harness

  1. Connect the C-5256 Machine Start Harness to the female taps leading into the Machine Control Assembly where the coin drop was previously connected.

Step 4 - Connect and Mount FasCard Reader

  1. Feed remaining harness ends through mounting hole as described in F2 Reader Mounting Guide.
  2. Connect the free end of the C-5256 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image below.
  3. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Connection Port) as shown in the image below.
  4. Connect FasCard reader to base as described in the F2 Reader Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models