Kit Installation Notes

Installation Kit

Recommended Tools and Supplies (Not Included)

See F2 Reader Mounting Guide for more information.

Installation

Step 1 - Install Mounting Bracket

  1. Run the C-6205 Power Adapter Harness and the C-0110-TOP Machine Start Harness through the circular opening on the C-6936 Vault Mount Bracket.
  2. Spread the bracket wings to lock it into place once installed.
  3. Insert the C-6936 Vault Mount Bracket into the Coin Vault
  4. Run the C-6205 Power Adapter Harness and the C-0110-TOP Machine Start Harness through the circular opening on the C-5414 F2 Mounting Bracket.
  5. Use the C-0144 screws, attach the C-5414 F2 Mounting Bracket to the C-6936 Vault Mount Bracket.

Step 2 - Connect Power

  1. Connect the C-6204 12VDC Power Harness to the H10 Connection on the Machine Control Assembly.
    1. Connect the green wire to a chassis ground.
  2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

Step 3 - Connect Machine Start Harness

  1. Connect the C-5300-NC Machine Start Harness to the where the Coin Drop connects to the Machine Control Assembly.
    1. The opposite end of this harness connects directly to the FasCard reader.
  2. Connect the C-5365 Bypass Harness to the appropriate connections to bypass the Coin Vault Switch.

Step 4 - Connect and Mount FasCard Reader

  1. Feed remaining harness ends through mounting hole as described in F2 Reader Mounting Guide.
  2. Connect the free end of the C-5300-NC Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
  3. Connect the free end of the C-6205 Power Adapter Harness to port 1 (Power Connection Port) as shown in the image above.
  4. Connect FasCard reader to base as described in the F2 Reader Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models