Kit Installation Notes

Installation Kit

Recommended Tools and Supplies (Not Included)

See F1 Reader Mounting Guide for more information.


Step 1 - Install Mounting Bracket

  1. Remove any existing Coin Drop and Coin Box.
  2. Install the C-5760-A Adapter Bracket onto the C-5762 Metercase Bracket.
  3. Install the C-5762 Metercase Bracket over the front of the Metercase and secure with C-1070-W Washer and C-1059 Nut.
  4. Refer to FasCard Mounting Guide for further information as needed.

Step 2 - Connect Power

  1. Connect the C-6204-40 12VDC Power Harness to the H10 Connection on the Machine Control Assembly.
    1. Connect the green wire to a chassis ground.
  2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

Step 3 - Connect Machine Start Harness

  1. Connect the C-5240 Machine Start Harness to the H3 connection on the Machine Control Assembly serial port.

Step 4 - Connect and Mount FasCard Reader

  1. Feed remaining harness ends through mounting hole as described in F1 Reader Mounting Guide.
  2. Connect the free end of the C-5240 Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
  3. Connect the free end of the C-6204 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown in the image above.
  4. Connect FasCard reader to base as described in the FasCard Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models