Kit Installation Notes

Install Kit (K-5704-CO)

Recommended Tools and Supplies

See F1 Reader Mounting Guide for more information.


Installation

Step 1 - Install Mounting Bracket

  1. Remove any existing Coin Drop.
  2. Install the C-5761 Metercase Bracket over the front of the Metercase.
  3. Refer to F1 Reader Mounting Guide for further information, as needed.

Step 2 - Connect Power

  1. Connect the C-6204 12VDC Power Harness to the H10 Connection on the Machine Control Assembly.
    1. Connect the green wire to a chassis ground.
  2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

Step 3 - Connect Machine Start Harness

  1. Connect the C-5300-NC Machine Start Harness to the harness previously connected to the Coin Drop.
    1. The opposite end of this harness connects directly to the FasCard reader.

Step 4 - Connect and Mount FasCard Reader

  1. Feed harness ends through mounting hole as described in the FasCard Mounting Guide.
  2. Connect the C-5300-NC Machine Start Harness to port 2 (Pulse Communication Port) as shown above.
  3. Connect the C-6204 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown above.
  4. Connect FasCard reader to base as described in the F1 Reader Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.


Associated Equipment Models