Kit Installation Notes

Technical Support recommends reviewing the following additional configuration information before installation: LG Giant-C Washer Configuration.

This installation also requires a Greenwald Coin Interface harness, included with Coin Ready machines.  If this component is absent, it may be necessary to contact a Greenwald distributor for assistance.

Installation Kit

Recommended Tools and Supplies (Not Included)

See F1 Reader Mounting Guide for more information.

Installation

Step 1 - Install Mounting Bracket

  1. Attach the C-5700 Surface Mounting Bracket to the C-6701 Adapter Plate using C-5702 Chase Nipple and C-5703 Nut.
    1. Make sure to orient the bracket so the two mounting holes on the C-6701 Adapter Plate are accessible (Fig 1).
  2. Place the newly assembled component on the outside of the machine, and place the C-0930 Mounting Bracket on the inside.
  3. Use the C-0144 Screws to attack the C-0930 Mounting Bracket to the outer components.

Fig. 1Fig. 2

Step 2 - Connect Power

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
  2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
  3. Connect the C-5500-60 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Step 3 - Connect Machine Start Harness

  1. Connect the C-5345 Machine Start Harness to the Coin Input Connection on the Machine Control Assembly.

Step 4 - Connect and Mount FasCard Reader

  1. Feed remaining harness ends through mounting hole as described in F1 Reader Mounting Guide.
  2. Connect the free end of the C-5345 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the free end of the C-5500-60 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown in the image above.
  4. Connect FasCard reader to base as described in the FasCard Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models