Kit Installation Notes

Install Kit (K-5704-CO)

Recommended Tools and Supplies

See F1 Reader Mounting Guide for more information.


Installation

Step 1 - Install Mounting Bracket

  1. Place the C-5700-TEMP Drill Template on the desired mounting location.
    1. Front Mount over card reader slot recommended.
    2. Alternative top mount can be used, recommend obtaining C-5633-R1 Label to cover card slot.
  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.
  3. Refer to F1 Reader Mounting Guide for further instructions.

Step 2 - Connect Power

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
  2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
  3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Step 3 - Connect Machine Start Harness

  1. Remove the existing Alliance Jumper Plug at H8 and connect the C-0110-CP Jumper Plug to the Machine Control Assembly.
  2. Connect the C-0110-TOP Machine Start Harness to the Machine Control Assembly at H5.
    1. The opposite end of this harness connects directly to the FasCard reader.

Step 4 - Connect and Mount FasCard Reader

  1. Feed harness ends through mounting hole as described in the FasCard Mounting Guide.
  2. Connect the C-0110-TOP Machine Start Harness to port 1 (Serial Communication Port) as shown above.
  3. Connect the C-5500 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown above.
  4. Connect FasCard reader to base as described in the F1 Reader Mounting Guide.
  5. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models