Kit Installation Notes

Installation Kit

Recommended Tools and Supplies (Not Included)

See FasCard Mounting Guide for more information.

Installation

Step 1 - Install Mounting Bracket

  1. Place the C-5700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to FasCard Mounting Guide for further instructions.

Step 2 - Connect Power

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5203 Power Adapter Harness to terminal strip or contacts L1 and L2.

    1. Connect the ground wire to a chassis screw.

    2. Connect the opposite end to the C-5602 Power Converter.

  2. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Step 3 - Connect Combination Coin Sense / Machine Start Harness

  1. Disconnect the Coin Drop.

  2. Connect the C-5381 Coin Sense Harness to the Coin Eye Sensor on the Coin Drop.

    1. Connect the taps to the Coin Block terminals.

  3. Connect the remaining connector where the coin drop was previously connected.

Step 4 - Connect and Mount FasCard Reader

  1. Feed remaining harness ends through mounting hole as described in FasCard Mounting Guide.

  2. Connect the free end (white connector) of the C-5381 Combination Harness to port 2 (Pulse Connection Port) as shown in the image above.

  3. Connect the free end (black connector) of the C-5381 Combination Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.

  4. Connect the C-5500 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown above.

  5. Connect FasCard reader to base as described in the FasCard Mounting Guide.

  6. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models