Kit Installation Notes

This machine needs to be configured for Card Mode as described here: Enable Card Mode on Wascomat Crossover.

Installation Kit

Recommended Tools and Supplies (Not Included)

See FasCard Mounting Guide for more information.

Installation

Step 1 - Install Mounting Bracket

  1. Install bracket provided with card ready machine.
    1. Pass cables through slot and connect before mounting reader using hardware provided.

Step 2 - Connect Power

  1. Connect the C-5350 Power Harness to the mated power harness inside the machine.
  2. Secure the ground wire terminal beneath a chassis screw.

Step 3 - Connect Coin Sense Harness

  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect the C-5352 Coin Sense Harness to the harness connected to the Coin Drop.

Step 4 - Connect Machine Start Harness

  1. Connect the C-5355 Machine Start Harness to the Machine Control Assembly ribbon cable.

Step 5 - Connect and Mount FasCard Reader

  1. Feed remaining harness ends through bracket slot.
  2. Connect the free end of the C-5355 Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
  3. Connect the free end of the C-5352 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  4. Connect the free end of the C-5350 Power Harness to port 4 (C-5500 Power Harness Connection Port) as shown in the image above.
  5. Connect FasCard reader to base as described in the FasCard Mounting Guide.
  6. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models